Burner Reconditioning - Standard Plus Rebuild pump coupler

Burner Reconditioning - Standard Plus Rebuild pump couplerINOV8 has a program to restore your INOV8 waste oil burner to "good condition" even if it's in pieces like the one in the photo. We take the burner apart and thoroughly clean all components inside and out, reassemble and test on a cycle timer to simulate normal operation. There are three levels all based on the age and condition of the burner. Standard Rebuild For burners up to five years the standard rebuild is recommended. The "standard" includes a

a 10-32 x 1/8 slip elbow

This Suntec Pump is specially modified and cannot be replaced without getting it from INOV8

Delta solenoid valves

124 and 177 GPH

The model numbers used are A2RA-7736

G215 & G315 boilers

In most cases we recommend that the rope seal is also replaced

a lid that provides vapor separation

That means it is self priming

It is installed inside the steel module block of the INOV8 burner and senses and communicates the temperature to the DTC

The top surface of it glows red hot with fire passing over the top of it

It looks like the photo and can be removed from the burner easily and within a few seconds